Search

Seneca Woodworking Clamp Dog for Festool MFT Table

M5085801 Available: Not Available - Out of Stock
The Seneca Woodworking Clamp Dog is a combination bench dog and clamp mounting plate designed for the Festool MFT tables.  The dog portion allows you to take advantage of the grid of holes in the MFT to make precise cuts. The clamp portion of the Clamp Dog is pre-drilled with mounting holes that allow you to attach either a Kreg Automaxx Bench Klamp, or a Bessey Auto-Adjust Toggle Clamp for quick, accurate clamping of your workpiece.

Seneca Woodworking Clamp Dogs are designed with the clamp mount "tangent" to the MFT dog, rather than on center. Our design also uses hole offset dimensions similar to Qwas Products Qwas Dogs and other similar MFT dogs on the market, so they can be used interchangeably for accurate positioning. This "tangent" design, allows the clamp to pivot around the mounting hole, rather than on top of it. This allows more usable workspace on the MFT, and also allows the clamps to be positioned at various angles for more effective clamping, while not affecting the positioning of the workpiece.

Machined from a solid block of aircraft grade aluminum and anodized black, the Seneca Woodworking Clamp Dogs will give you years of reliable service.

Included with each Clamp Dog are mounting hardware for Bessey Toggle Clamps (Kreg clamps include mounting hardware) and a hand knob to secure it to the MFT table.
$39.95 Regular Choose Options OUT OF STOCK

Seneca Woodworking Domi-Shim for DF700

M5085803 Available: 3
The Seneca Woodworking  Domi-Shim is a machined aluminum shim that attaches to the fence on the Festool Domino XL DF 700 and allows centering on narrower stock than was previously possible. This shim allows the Domino XL fence to adjust all the way to the cutter centerline, allowing centering on material thinner than the Domino XL fence's  lower travel limit would previously allow.   This shim can be used with the Domino XL in several ways:
-By itself, using a rule or setup block to adjust the fence to achieve the proper offset for a variety of material thicknesses, both imperial or metric.
-By itself with the Domino XL fence offset gauge set to "15mm." This creates the correct offset for centering a mortise on 1/2" nominal plywood.
-The Domi-Shim is machined from aluminum, black anodized and laser-engraved. Mounting hardware is included.
$36.99 Regular Choose Options OUT OF STOCK